Band pass filter footprint issue

Dear SAn,

Hope you are fine nowadays.

I required your valuable help and guidance regarding the below query raised by our RF team.

Can you please confirm the updated part no used in the Dragino Board for the reference designator As per schematic ) " F12" and “F15” band pass filter used both RF path of 2.4 GHz Radio of the core board?

Team has observed that schematic pin outs and part footprint in layout both were different and therefore part mentioned in original BOM downloaded from the community need to solder by rotating 180 degree to match the RF in/out pin outs of band pass filter.

Hope to hear from you at the earliest.

Dear All,
Any update on above ?

Thanks & Best Regards,
Nikunj Patel

Dear All,
Any update on above ?

Thanks & Best Regards,
Nikunj Patel

Hi, sorry for the delay. I am not sure about the answer. Does a detailed image of the Core board help you?

Dear SAN,

Sorry, can you please elaborate the meaning of “detailed image”?

Thanks & Best Regards,
Nikunj Patel

I mean a photo / picture